This post shows my screenshots from the console of my Eaton 5PX as it was powered on.
In this post:
- Eaton 5PX 2200
I was trying to clear the Replace Battery warning on my UPS after recently replacing the batteries.
At present, the warning message has been cleared, I’m not sure how or why.
Before taking these screen shots, the server connected to the UPS was not loading up the driver. This was caused by a disconnected data cable. Reconnecting that cable fixed that issue. The UPS process on the server was restarted. Normal service resumed. The warning message was gone.
Since I have them, I’m posting the screen shots.
As mentioned in my NUT mailing list post, the console had been displaying a repeating cycle of output:
Local database initialisation - state_bind_error - * END state_bind_error * Local database initialisation - state_bind_error - * END state_bind_error * Local database initialisation ...
I’m unsure as to why those messages occurred. You can see the last of them in the following screen shot as I powered off the UPS disconnected it for two minutes, then reapplied power.
Network nearly ready to load up:
There comes the network:
This is where I saw the looping before:
And we get past the database initialisation phase….
It was outside the this process that the data cable was reconnected and regular service resumed.
