nut

Complete network shutdown – wtf?

Leave a Comment / Eaton, General, nut, UPS / By /

This afternoon, I was running an Ansible script to update the snmpd configuration settings on nagios03 (which replaced nagios02 – which was intentionally destroyed earlier today). After the script completed, I could not access the ngaios3 website, nor could I ssh into the host. My first thoughts: I must have messed up the ssh configuration, I’ll fix it through the console. I can’t get to anything. Anywhere. WIFI now? No, it’s me that’s […]

Complete network shutdown – wtf? Read More »

Optimizing UPS power use when the power goes out

Leave a Comment / Eaton, Network monitoring, nut, UPS / By /

This post is mostly for myself. I’m just putting my Sunday morning thoughts down for later review and consideration. When Selecting replacements batteries for my Eaton 5PX UPS (5PX2200RT & 5PXEBM48RT), I began to think about: when the power goes off, why can’t I keep using my laptop? Usually, I still have an Internet connection: the ISP isn’t going offline. Why not turn off the two servers in the basement, and anything else

Optimizing UPS power use when the power goes out Read More »

nut – testing shutdown and startup

7 Comments / nut, UPS / By /

Today I tested the shutdown but was mostly concerned by the startup. I wanted the hosts to start in a specific order. I lived tweeted it and that thread is the basis for this post. The UPS has three groups of outlets: primary group, group 1, group 2. Each group has a On Delay setting. You could choose which gear to power on first. I have all mine set to zero, so all

nut – testing shutdown and startup Read More »

nut – testing the shutdown mechanism

Leave a Comment / FreeBSD, nut, Open Source / By /

Following on from my recent nut setup, this is the second in a series of three posts. The next post will deal with adjusting startup and shutdown times to be sure everything proceeds as required. I want to test the host shutdown mechanism without: unplugging the UPS from the mains powering off the UPS without powering off the servers I have just updated all the hosts and the jails on those hosts. This

nut – testing the shutdown mechanism Read More »

Monitoring your UPS using nut on FreeBSD

Leave a Comment / FreeBSD, Nagios, nrpe, nut, Open Source, UPS / By /

It is time to replace my existing UPS with another one. I’m getting only 3 minutes of runtime with the existing batteries (and new batteries, after recalibration). It was suggested I buy an Eaton 5PX. I wasn’t convinced. This is the first of three articles about nut. The second is about testing the shutdown. The third will be about testing both shutdown and startup timings. Two days later, I’d purchased a new Eaton

Monitoring your UPS using nut on FreeBSD Read More »

Scroll to Top