I have a system with three tape drives and two tape changers. If one tape library is powered off when the system boots, the device names for the other tape library may be skewed. That is, /dev/sa0 may not be the LTO-4 drive, it will be the SDLT drive. This is not ideal. FreeBSD uses […]
Using device.hints to wire physical devices to specific names Read More »
In this post: Bacula 7.4 FreeBSD 11.1 py-iocage 0.9.9.2 I recently wrote about Converting a Dell R710 into a ZFS-based FreeBSD 11.1 tape library bacula-sd and then about getting the drives ready. That system, henceforth referred to as the r710 is now ready for the Bacula setup. Last night I created a jail and installed
Moving bacula-sd into a FreeBSD jail Read More »
Last night, I added a SAS card into a box which is connected to a tape library (photos here). After starting up the box, Nagios reported that the tape device was no longer present. I first added such checks back in 2012 and updated them for more recent acquisitions. This means that the copy-to-tape jobs
Adding in a SAS card renumbered my devices Read More »
I am fortunate to receive donations. In the early days, it was a 386 desktop. Later, it was SCSI drives. Recently, it’s been tape libraries. A Bacula user in Europe donated an Overland DLT-8000 tape library in 2012 and paid for shipping to me. At BSDCan 2013, I was fortunate to pick up an Compaq
Using the Compaq Storage Works MSL5026 Library Read More »
This article talks about FreeBSD 8.2 and how device names might change when you add new devices to an existing system. The other day, when I was telling you about the new tape library, one of the important bits was the device names. The existing tape drive was sa0. The new one was sa1. That’s
Hardcoding device names Read More »